Fenders

The RO-MAR
buoys and fenders are delivered with an eyelet at both ends as well as safety stripes. Customers labels are optional extras.

The RO-MAR
buoys and fenders are delivered deflated packed on pallets and are very easy to handle and only take up little space when stored deflated on board.

By using an air compressor with a high capacity and low pressure the buoys and fenders are inflated and deflated again within minutes.

The RO-MAR
bouys and fenders are easy to handle, very difficult to damage and like all ROULUNDS' marine products very reasonably priced.

Physical data:
Working pressure: 0. 1- 0.2 Bar
Burst pressure: ~ 1 Bar


Material used:
Reinforcement: Polyester fabric
Carcass rubber: Polychloroprene / SBR
Coating rubber: Hypalon


It is adviseable to use a low pressure / high volume pumping unit.

• By filling, any supply device can be used, as no fixed connection to the fender (buoy) is adviseable. Fill the fender untill it is fully shaped and the surface feels firm and stable. A build-in rubber flap works as a non return valve and gives you the time necessary for packing and tightening the valve cap.
• Check the working pressure occasionally for optimal operation.
• The valve thread should be re-packed for tightness after every pressure check.
• Algae etc. should be removed.

See factory website  Ro-Clean Desmi

After 2 minutes

After 5 minutes

After 10 minutes

After 15 minutes

RO-MAR 0,2 (200 litre)

RO-MAR 6.000 litre